H&R Sway Bar Kit – BMW 228i & 230i (F22/F23, N20/B46)

OVERVIEW

H&R's matched front & rear sway bar set for the F22/F23 228i and 230i increases torsional stiffness over the factory bars to reduce body roll and sharpen turn-in. The front bar is two-hole adjustable, letting you choose between a street-friendly setting and a stiffer track setting to fine-tune handling balance.

SPECS

• 28mm front bar / 20mm rear bar
• Front bar is two-hole adjustable for street/track roll-stiffness tuning
• Larger diameter than the factory bars for reduced body roll
• Includes H&R mounting bushings and hardware

PARTS INCLUDED

• Front sway bar
• Rear sway bar
• H&R mounting bushings and hardware
• Installation instructions

TECH RESOURCES

Additional Parts Required

• None. H&R includes the mounting bushings and hardware needed for installation.
• A four-wheel alignment is recommended after installation (service, sold separately).

Installation

• H&R general technical & installation information (PDF, hosted on our Shopify) — H&R does not publish a sway-bar-specific install guide separate from this general technical document.

Notes

• This kit is specific to 228i/230i; the F22 M235i/M240i uses a different H&R part — 72878-2.

PART NUMBER

• 72878 — Front & Rear Set

VEHICLE APPLICATIONS