H&R Super Sport Spring Kit – BMW M3 (G80)

OVERVIEW

Suspension is one of the biggest factors in how a car drives day to day, and upgrading the stock springs is the first step in suspension tuning. H&R Super Sport Springs for the G80 M3 and M3 Competition drop the car about 1.4" at the front and 1.0" at the rear, reducing body roll and improving handling while keeping the ride comfortable.

Super Sport Springs carry all the features of H&R Sport Springs plus additional lowering, with a progressive rate design that stays composed under load without turning the car harsh on the street.

H&R Special Springs will not set or sag. They are crafted from a special (hf) 54SiCr6 spring steel and shot-peened to increase their life by more than 200%. All production is completed in-house, and each spring is 100% tested before leaving H&R's ISO9001-certified production facility in Germany.

SPECS

• Approximate front lowering: 1.4"
• Approximate rear lowering: 1.0"
• Super Sport specification — Sport Spring features plus additional lowering
• Progressive spring rate design
• Crafted from special (hf) 54SiCr6 spring steel
• Shot-peened to increase spring life by more than 200%
• Will not set or sag
• All production completed in-house in Germany; each spring 100% tested
• ISO9001-certified production

PARTS INCLUDED

• Complete H&R Super Sport Spring kit as supplied by H&R Springs — front and rear springs. See the installation instructions for the full bill of materials.

TECH RESOURCES

Additional Parts Required

• None. H&R specifies no additional hardware for this spring kit.
• Four-wheel alignment after installation — H&R states that alignment must be checked after any suspension ride height modification.
• Professional installation — H&R states that its springs and suspensions should be installed by professional suspension mechanics only.
• A spring compressor and standard strut service tools, supplied by the installer, are required to disassemble the factory struts on this spring-only kit.
• The G80 M3 uses adaptive M dampers. Confirm with Speed Logic that this kit is specified for your car's damper configuration before ordering.

Installation

• H&R Technical Information & Installation Guide (PDF) — spring markings (F/VA front, R/HA rear), ride height measurement, bumpstop trimming table, alignment requirements.
• H&R installation FAQ (hrsprings.com) — spring orientation, progressive rate springs, ride height measurement and post-installation alignment.
• Follow the factory service manual procedure for spring replacement on the G80 chassis.

Notes

• The existing listing did not state model years; the years shown reflect G80 M3 production. H&R's official kit number for this application could not be verified on hrsprings.com, so no part number is published here. Please confirm exact fitment and part number with Speed Logic before ordering.

VEHICLE APPLICATIONS